10 Best Co2 Detector of March 2024

List of Top Rated Co2 Detector from thousands of customer reviews & feedback.

Updated On Mar 2024

854 Reviews Studied

By Customer Ratings

1
Image
Kidde Nighthawk Plug-In AC/DC Carbon Monoxide Alarm Detector with Digital Display KN-COPP-3 Read Review

  • Peak level button – Displays the peak CO level recorded by the alarm since it was last reset or unplugged
  • Test button functions – Tests the unit for proper operation and resets the carbon monoxide alarm
  • LED operation – Blinking dot in lower right corner of display denotes normal operation
  • Ten years after the initial power up, this alarm will “beep” two times every 30 seconds to indicate that it is time to replace the alarm.
  • Note: This CO alarm is not battery operated. However, these alarms are equipped with 9 volt battery backup – the 9 volt battery is to supply short term back-up during a power outage.
  • Power source: 120VAC. Temperature range-40˚F (4.4˚C) to 100˚F (37.8˚C). Humidity range-5%-95% relative humidity (RH)

2
Image
Kidde Carbon Monoxide Detector Alarm |Battery Operated | Model # KN-COB-LP2 9CO5-LP2 Read Review

  • 2 AA battery backup
  • Low battery hush
  • Event memory
  • Loud 85 decibel alarm
  • Low battery signal

3
Image
Kidde Carbon Monoxide Alarm Detector | Digital Display | Battery Operated | Model KN-COPP-B-LPM Read Review

  • LED's - Green LED for normal operation, Red LED for alarm. Temperature range 40˚F (4. 4˚C) to 100˚F (37. 8˚C). Sensor: Electrochemical
  • Provides peace of mind against the silent killer and a digital display
  • Digital Display - Displays the level of carbon monoxide the unit is sensing. Shows CO level in PPM (parts per million). Updates digital reading every 15 seconds allowing you to see if levels change. Peak Level Memory displays the highest CO concentration measured since the last reset
  • Battery Operated - Provides best protection during power outages. Battery Safeguard makes it difficult to close the cover without batteries in the unit. Low Battery Signal alerts user when the batteries need to be replaced. Slide-Out Battery Door Cover gives immediate access to batteries
  • Test/Reset Button - Tests unit’s electronic circuitry & horn and resets the unit during alarm. Tests CO alarm circuit operation and allows you to immediately silence the alarm

4
Image
Kidde AC Carbon Monoxide Detector Alarm | Plug-In with Battery Backup | Model KN-COP-DP2 Read Review

  • Tamper resist feature – Can be activated to cause unit to go into alarm if it has been unplugged or has come loose from the outlet
  • Two LED’s: Red - Illuminates when in alarm mode. Green – AC power is present, normal operation
  • Test/reset button: Tests CO alarm circuit operation and allows you to immediately silence the alarm
  • End of life alarm: Alerts user to replace CO alarm after 10-years of operation
  • Provides peace of mind against the silent killer; Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)

5
Image
First Alert CO605 Plug-In Battery Backup CO Alarm, 1 Pack, White Read Review

  • Keep your family safe with this easy to use plug in carbon monoxide alarm; It works with any standard outlet and also has a battery backup for continuous monitoring of Carbon Monoxide levels, even if there's a power failure
  • Features an advanced electrochemical carbon monoxide sensor that accurately detects carbon monoxide levels, no matter where the detector is placed in the room
  • Simple to use, with a single test/silence button; A loud 85 decibel alarm sounds when carbon monoxide levels reach dangerous levels. Low battery signal mute, quiets low battery signal for up to 8 hours
  • To ensure complete protection make sure to place one on each level of your home and in each bedroom
  • 7 year limited warranty; Equipped with end of life signal chirp, so you know when it’s time to replace the unit for safety
  • All first alert CO alarms are rigorously tested to meet UL standards. Item length is 3.4 inches, item width is 1.38 inches and item height is 5 inches
  • First Alert has been the most trusted brand in home safety since launching the first residential smoke alarm in 1958 (Based on a First Alert Brand Trust Survey in February 2018)

6
Image
First Alert CO400 Carbon Monoxide Detector, White, Pack of 1 Read Review

  • Keep your family safe with this easy to use, battery operated carbon monoxide alarm; Battery powered alarms provide continuous monitoring of CO levels, even if there's a power failure
  • Features an advanced electrochemical carbon monoxide sensor that accurately detects carbon monoxide levels, no matter where the detector is placed in the room
  • A loud 85 decibel alarm sounds when CO levels reach dangerous levels
  • To ensure complete protection make sure to place one on each level of your home and in each bedroom
  • 7-year limited warranty; Equipped with end of life signal chirp, so you know when it’s time to replace the unit for safety
  • All first alert CO alarms are rigorously tested to meet UL standards
  • First Alert has been the most trusted brand in home safety since launching the first residential smoke alarm in 1958 (Based on a First Alert Brand Trust Survey in February 2018)

7
Image
Kidde 21026043 Battery-Operated(Not Hardwired) Combination Smoke/Carbon Monoxide Alarm with Voice Warning KN-COSM-BA Read Review

  • Voice Alarm –Announces the hazard type detected thereby helping to speed up the correct reaction to the hazard detected. Alarm announces “Fire ” when a smoke or fire hazard is detected and announces “Warning Carbon Monoxide” when a CO hazard is detected
  • Combined Carbon Monoxide and Smoke Alarm – A single unit can be installed where previously, two were needed. Reduces installation time and helps to keep home décor attractive.
  • Audio alarm: 85 dB at 10 feet. Test/Reset Button and LEDs – Tests alarm circuitry and triggers the voice announcement. Flashing green for normal operation and flashing red for alarm condition. Humidity Range: 10 percent to 95 percent relative humidity non-condensing
  • Battery - Provides protection even during power outages when many fire and carbon monoxide incidents occur. The unit warns of a low battery condition by announcing “low battery” and by initiating an alarm chirp and activating a flashing red LED. The battery door will not close unless the batteries are properly installed. Note : The date printed on the item is manufacturing date, not the expiration date. Refer to the PDF attached below in Technical Specification for Manual.
  • Voice Announcements - Hush Feature temporarily silences nuisance alarms with “HUSH MODE ACTIVATED” and “HUSH MODE CANCELLED” voice announcement. If the alarm had detected a CO level of 100ppm or higher, the unit will announce “CARBON MONOXIDE PREVIOUSLY DETECTED” to warn of the CO incident, when the Test/ Reset button is pressed. Temperature Range: 40˚F (4. 4˚C) to 100˚F (37. 8˚C). Voltage (volts): 4. 5

8
Image
First Alert Smoke Detector and Carbon Monoxide Detector Alarm | Battery Operated, SCO5CN Read Review

  • Keep your family safe with this battery operated smoke and carbon monoxide alarm; Battery powered alarms provide continuous monitoring of CO levels, even if there's a power failure
  • Features an electrochemical carbon monoxide sensing technology as well as a photoelectric sensor that detects the larger particles of a smoldering fire
  • Indicator lights on the face of the unit display the presence of smoke or carbon monoxide, while an 85 decibel siren provides a clear, loud warning upon detection
  • Battery operated unit installs quickly and easily without an electrician. Low battery signal mute, quiets low battery signal for up to 8 hours
  • Simple to use, with a single test/silence button; EZ access battery drawer allows you to change battery without removing alarm from ceiling
  • 7 year limited warranty; Equipped with end of life signal chirp, so you know when it’s time to replace the unit for safety; All first alert alarms are rigorously tested to meet UL standards
  • It can ship within the US except New York
  • First Alert has been the most trusted brand in home safety since launching the first residential smoke alarm in 1958 (Based on a First Alert Brand Trust Survey in February 2018)

9
Image
Carbon Monoxide Detector 3 Pack CO Alarm Detector Voice Notification, LCD Digital Display, Battery Operated for House, B... Read Review

  • 【High Sensitive & Quick Responsive】Build-in smart Carbon Monoxide Detector Chip and the electrochemical sensor, Enough to detect smoke and odorless, invisible and deadly carbon monoxide in the air, Quick reaction to save your life in the first time when fire hazard occurs.
  • 【Component Advantage】Human Voice Notification Prompt, High reliable electrochemical sensor, Corbon monoxide concentration displaying (PPM), Low Current consumption, Ultra-long Standy time, Alarm Memory Function, Low Battery Prompt, Auto Detect Sensor Failure.
  • 【LCD Digital Display】CO Detector offers Voice Notification and a digital readout of the CO concentration. Detecting level range: 0-999PPM. Alarm concentration: 30-999PPM. It can display both current reading and a peak reading from memory of the highest level measured over a period of time.
  • 【Easy Installation & Widely Used】Coming with mounting bracket, screws and anchor plugs, just drill holes in appropriate positions, and done; Used for Each bedroom sleeping area in your home kitchen and living room, and any rooms with an increased risk of fire danger can be installed a smoke detector and carbon monoxide alarm.
  • 【Warranty and Service】18 months worry-free product guarantee ensures long-lasting enjoyment of your purchase.And please contact seller first once you have any questions.

10
Image
Kidde AC Plug-in Carbon Monoxide and Explosive Gas Detector Alarm | Nighthawk Sensor Technology | Model # KN-COEG-3 Read Review

  • Protects you and your family from two deadly threats: Carbon monoxide and explosive gas.
  • Sounder alarm – The KN-COEG-3 offers a loud 85-decibel pulsing alarm that will sound to alert you to a potential problem.
  • Digital display - Displays the level of carbon monoxide the unit is sensing.
  • Peak level memory - Recalls the highest CO concentration detected
  • Test/reset button - Tests unit’s electronic circuitry operation and allows you to immediately silence the alarm
  • Two alarms in one detects carbon monoxide and explosive gas
  • Three convenient mounting options
  • Digital display and peak level button displays the peak CO level recorded by the alarm since it was last reset
  • Battery backup 9 volt battery included
  • Kidde’s carbon monoxide alarms meet the requirements of Underwriters Laboratories (UL), an independent facility that tests products for compliance with widely-accepted safety standards